Instructions

Gen II

Switch on
Press the on/off button. The red LED light will come on.
Switch off
Press and hold the on/off button for 3 seconds. The red LED light will go off.
Auto shut off
If the device is left on for more than 30 seconds without being in the record mode or being used to record stills, it will turn off to conserve battery power.
Recording
Press record button once quickly to take still photo.

Press and hold record button for 3 seconds and the device will start recording video.

The red LED light will blink continuously during record mode. This can be seen in your peripheral vision.
Stop recording
One short press of the record button will end video recording. The red LED light will blink rapidly which indicates the device is saving data. When the rapid blinking ends the device is ready for the next recording or taking stills.
PC Connection
Plug the supplied USB cable to the turned off device and then to the computer.

The computer will recognize the device as an external hard drive.

Click on external hard drive and a folder “DCIM” will appear. This contains the videos and still photos. You can then copy or cut and save to your hard drive.

Be sure to click “Safely remove hardware” before disconnecting the device from your PC.
Battery
Charge using the supplied charger and cable. The device will also charge via the USB connection to you PC.

Charge with the device powered off for best protection.
TIPS
If the device locks up. Take a paper clip and insert in reset port.

Do not rapidly switch between still and video modes or press off button until the files have been stored.

Take care not to press on SD card while activating controls

Format SD card before using.

You can delete files from SD card but the best is to format it to remove files.
Right click on external hard drive icon when connected to PC.

Format will be on list. Click to format SD card.
As with any electronic device care should be taken to prevent exposure to water.





Gen I

Switch on
Press the on/off button. The green LED light will blink once, and then it blinks once more along with the blue LED light. When the blue LED light turns off and only the green is light, the device is ready for recording.
Switch off
Press the on/off button to turn off.
Auto Shut off
If the device is left on for more than 30 seconds without being in the record mode, it will shut off to conserve battery power.
Recording
Press record button to start video, the blue LED will blink continuously during recording. This can be seen in your peripheral vision.
Stop recording
One short press of the record button will end recording. The blue LED light will flash rapidly, which indicates the device is saving data. When the rapid blinking ends, the device is ready for the next recording.
PC connection
Plug the supplied USB cable to the turned off device and then the computer.

The computer will recognize the device as an external hard drive.

Click on external hard drive and a folder “DCIM” will appear. This contains the videos. You can then copy or cut and save to your hard drive.

Be sure to click “Safely remove hardware” before disconnecting the device from your computer.
Battery
Charge using the supplied charger and cable. The device will also charge via the USB connection to your computer.

Charge with the device powered off for best protection.
TIPS
If the device locks up. Take a paperclip and insert in reset port.

Allow time for the device to store data after stopping recording before pressing any buttons.

Take care not to press on SD card while activating controls.

Format SD card before using.

You can delete files from the SD card but the best is to format it to remove files.
Right click on external hard drive icon when connected to PC

Format will be on list. Click to format SD card.
As with any electronic device care should be taken to prevent exposure to water

Features

Capture video or still photos (Gen II)

3 sets of interchangeable polarized lenses included: green, yellow and clear

User friendly operation button for easy control

Sleek and elegant design meets your taste for life

Easy connection with PC/Laptops, no driver needed

Operating systems: Win98, WinMe, WinXP, Win2000, Windows Vista, MAC OSX

3-4 hours long power supply for video recording

4G complimentary TF card, for approximately 3 hours video audio recording

Memory card slot can support max 8GB TF/Micro SD card

Real time video recording , never let memorable moments sneak away

Used by...

  • hunters
  • trainers
  • anglers
  • skiers
  • pilots
  • drivers
  • police/military
  • security personnel